Skip to content
DRIZORO
Contact Us
MaxSeal® M
Cementitious Waterproofing

MaxSeal® M

Single Component Cement-Based Waterproof Coating For Concrete And Masonry

Pack
  • 25 KG BAG
Quality Certifications
  • CE
  • EPD - Environmental Product Declaration
  • Building Sustainable Future
Type
Single Component Cement-Based Waterproof Coating For Concrete And Masonry
Applications
Water Retaining Structures Waterproofing, Dams Waterproofing
Color
Grey
Coverage
1.0–1.5 kg/m² per coat (about 1 mm per coat) — total 2.0–3.0 kg/m² in two coats.

Request Sample

Select up to 3 samples

Select Sample (Max 3) *

Product Description

MaxSeal® M is a single component mortar made of a mixture of cements, selected aggregates, special additives and synthetic resins which provides a high-performance waterproof coating for concrete and masonry. It can be used for both positive and negative pressure.

Technical Data Sheet

ParameterValue
Product TypeSingle Component Cement-Based Waterproof Coating For Concrete And Masonry
Container Type & Size25 KG BAG
ColorGrey
Consumption1.0–1.5 kg/m² per coat (about 1 mm per coat) — total 2.0–3.0 kg/m² in two coats.

Note: The consumption and mixing ratios stated herein are nominal values determined under the manufacturer's recommended ideal conditions (20 °C and 50 % R.H.). Actual values may vary depending on ambient temperature, the pot life of the mix, the mixing tools and equipment used, the nature, condition and temperature of the substrate, the complementary practices adopted in the local market, and on-site trials according to each project's conditions and requirements. A preliminary on-site test prior to full application is always recommended.

Reference Standards

  • CE Marking, EN 1504-2 — Mortar for protection of concrete, Coating (C).
  • Principles/Methods: 1-PI/1.3, 2-MC/2.2, 8-IR/8.1
  • EN 12390-8 (9 bar positive / 3 bar negative) · EN 13892-2 · EN 1542
  • Suitable for contact with drinking water: EU Directive 2020/2184 and Spanish RD 03/2023 · BS 6920

How to Apply

How to Apply
Saturate the prepared substrate with clean water and drain the excess, leaving no standing water. Mix a 25 kg bag with 6.5–7.0 litres of clean water (27 ± 1 %) using a low-speed drill (400–600 rpm) for 2–3 minutes, leave to rest 5 minutes and re-mix briefly for 1 minute. Apply with a fibre brush (MAXBRUSH®) or nylon broom (MAXBROOM®) as a thick, continuous coat about 1 mm thick — not spread like paint and without overworking the fresh coating. Apply the second coat perpendicular to the first after 12–16 hours (24 hours maximum); it may also be applied by roller or trowel for decorative finishes, or sprayed by wet method. Allow 3 days before covering with tiles, renders or gravel and 10 days curing (20 °C / 50 % R.H.) before permanent immersion, pre-washing the surface with a water jet.

Packaging

25 KG BAG