Skip to content
DRIZORO
Contact Us
MaxPatch® M
Decorative & Finishing Systems

MaxPatch® M

One-Component, Patching Mortar For Repairing Concrete Floors And Continuous Decorative Finish In Minimum Thickness

Pack
  • 25 KG BAG
Quality Certifications
  • CE
  • EPD - Environmental Product Declaration
  • Building Sustainable Future
Type
One-Component, Patching Mortar For Repairing Concrete Floors And Continuous Decorative Finish In Minimum Thickness
Applications
Concrete Floors Restoration, Roads Restoration
Color
Grey
Coverage
Neat product: approx. 2.0 kg/m² per mm of thickness (a 25 kg bag fills about 12.5 litres). Extended with sand (8 kg of sand per 25 kg bag): approx. 1.4 kg/m² per mm, filling about 20 litres. Layer thickness 5–25 mm.

Request Sample

Select up to 3 samples

Select Sample (Max 3) *

Product Description

MaxPatch® M is a one-component mortar based on special cements, well-graded aggregates and additives. Once mixed, provide an advanced mortar with high performance and mechanical properties (adhesion, abrasion resistance and compressive strength) suitable for restoration and patching of concrete floors, ramps, steps, etc, subject to pedestrian or heavy vehicular traffic.

Technical Data Sheet

ParameterValue
Product TypeOne-Component, Patching Mortar For Repairing Concrete Floors And Continuous Decorative Finish In Minimum Thickness
Container Type & Size25 KG BAG
ColorGrey
Product Color OptionsWhite / Red / Green
ConsumptionNeat product: approx. 2.0 kg/m² per mm of thickness (a 25 kg bag fills about 12.5 litres). Extended with sand (8 kg of sand per 25 kg bag): approx. 1.4 kg/m² per mm, filling about 20 litres. Layer thickness 5–25 mm.

Note: The consumption and mixing ratios stated herein are nominal values determined under the manufacturer's recommended ideal conditions (20 °C and 50 % R.H.). Actual values may vary depending on ambient temperature, the pot life of the mix, the mixing tools and equipment used, the nature, condition and temperature of the substrate, the complementary practices adopted in the local market, and on-site trials according to each project's conditions and requirements. A preliminary on-site test prior to full application is always recommended.

Reference Standards

  • CE Marking, EN 1504-3 — Polymer-modified hydraulic cement mortar (PCC) for non-structural repair of concrete, class R3.
  • Principles/Methods: 3-CR/3.1 (mortar applied by hand)
  • EN 12190 · EN 1542 · EN 13295 · EN 13412 · EN 13687-1/-2/-4 · EN 13057 · EN 1015-17

How to Apply

How to Apply
Cut back the edges of the repair area at least 5 mm and saturate the substrate with water without leaving free standing water. Mix a 25 kg bag with 3.5–4.0 litres of clean water (14–16 % by weight) using a slow-speed drill (400–600 rpm) for 2–3 minutes. Brush on a bonding slurry (5 parts powder to 1 part water) and, before it loses its sheen, trowel the mortar in layers of up to 25 mm. Pot life is about 20 minutes; re-mix to restore workability but never add more water. Open to pedestrian, light and heavy traffic after 1, 2 and 5 days respectively.

Packaging

25 KG BAG