Skip to content
DRIZORO
Contact Us
MaxUrethane® Finish
Decorative & Finishing Systems

MaxUrethane® Finish

Transparent, Water-Based, Polyurethane Sealer For Protection Of Concrete Floors And MaxPatch® Decorative Mortars

Pack
  • Two ComponentsA: 22.5 KG PAILB: 2.5 KG PAIL
Quality Certifications
  • CE
  • EPD - Environmental Product Declaration
  • Building Sustainable Future
Type
Transparent, Water-Based, Polyurethane Sealer For Protection Of Concrete Floors And MaxPatch® Decorative Mortars
Applications
Transparent Concrete Floors Protection, Terrazzo Floors Protection
Color
Transparent / White
Coverage
80–100 g/m² per coat — 160–200 g/m² applied in two coats.

Request Sample

Select up to 3 samples

Select Sample (Max 3) *

Product Description

MaxUrethane® Finish is a two-component, water-based, aliphatic sealer which once applied on concrete floors and mortars, forms a protective transparent film resistant to wear and abrasion, which provides an anti-dust finish, easier cleaning and lower water absorption of the surface.

Technical Data Sheet

ParameterValue
Product TypeTransparent, Water-Based, Polyurethane Sealer For Protection Of Concrete Floors And MaxPatch® Decorative Mortars
Container Type & SizeTwo-component A: 22.5 KG PAIL B: 2.5 KG PAIL
ColorTransparent / White
Consumption80–100 g/m² per coat — 160–200 g/m² applied in two coats.

Note: The consumption and mixing ratios stated herein are nominal values determined under the manufacturer's recommended ideal conditions (20 °C and 50 % R.H.). Actual values may vary depending on ambient temperature, the pot life of the mix, the mixing tools and equipment used, the nature, condition and temperature of the substrate, the complementary practices adopted in the local market, and on-site trials according to each project's conditions and requirements. A preliminary on-site test prior to full application is always recommended.

Reference Standards

  • CE Marking, EN 1504-2 — Coating for protection of concrete surfaces. Test standards: EN 1062-6 (CO₂ permeability) · EN ISO 7783 (water vapour permeability) · EN 1062-3 (capillary absorption and water permeability) · EN 1542 (adhesion on concrete).

How to Apply

How to Apply
The substrate must be sound, uniform and dry (moisture content below 10 %); remove cement laitance, old coatings, efflorescence, dust, grease and oils, and patch voids and cracks with the appropriate epoxy or polyester mortar. Pour component B into component A (mixing ratio A:B = 9:1) and mix manually or with a low-speed drill (300–400 rpm maximum) for about 2–3 minutes until homogeneous; pot life 45 minutes. Apply with a short-pile enamelling roller or brush in a thin, uniform layer, in two crossed coats, allowing a minimum of 2 hours and a maximum of 24 hours between coats. Pedestrian traffic after 1 day; total curing 3 days at 20 °C and 50 % R.H.

Packaging

Two-component A: 22.5 KG PAIL B: 2.5 KG PAIL