Skip to content
DRIZORO
Contact Us
MaxPatch® M Fino
Decorative & Finishing Systems

MaxPatch® M Fino

Cosmetic One-Component Mortar For Continuous Decorative Finish Of Concrete Floor In Minimum Thickness

Pack
  • 25 KG BAG
Quality Certifications
  • CE
  • EPD - Environmental Product Declaration
  • Building Sustainable Future
Type
Cosmetic One-Component Mortar For Continuous Decorative Finish Of Concrete Floor In Minimum Thickness
Applications
Indoor Flooring Finish, Exterior Flooring Finish
Color
Grey / White
Coverage
Approx. 2.0 kg/m² per mm of thickness (a 25 kg bag fills about 12.5 litres). Layer thickness 1–5 mm over surfaces previously levelled with MaxPatch® M.

Request Sample

Select up to 3 samples

Select Sample (Max 3) *

Product Description

MaxPatch® M Fino is a one component cement-based mortar with selected aggregates and special additives. Once mixed with water, provides a mortar of high mechanical performance (adhesion, abrasion resistance and compression) and suitable for cosmetic/decorative finish of continuous pavements from 1 to 2 mm
thickness, on previously levelled surfaces with MaxPatch® M

Technical Data Sheet

ParameterValue
Product TypeCosmetic One-Component Mortar For Continuous Decorative Finish Of Concrete Floor In Minimum Thickness
Container Type & Size25 KG BAG
ColorGrey / White
Product Color OptionsOther colours upon special request
ConsumptionApprox. 2.0 kg/m² per mm of thickness (a 25 kg bag fills about 12.5 litres). Layer thickness 1–5 mm over surfaces previously levelled with MaxPatch® M.

Note: The consumption and mixing ratios stated herein are nominal values determined under the manufacturer's recommended ideal conditions (20 °C and 50 % R.H.). Actual values may vary depending on ambient temperature, the pot life of the mix, the mixing tools and equipment used, the nature, condition and temperature of the substrate, the complementary practices adopted in the local market, and on-site trials according to each project's conditions and requirements. A preliminary on-site test prior to full application is always recommended.

Reference Standards

  • CE Marking, EN 1504-3 — Polymer-modified hydraulic cement mortar (PCC) for non-structural repair of concrete, class R3. Covered by the same Technical Bulletin No. 333.02 as MaxPatch® M (maximum aggregate size < 0.4 mm).
  • Principles/Methods: 3-CR/3.1 (mortar applied by hand)
  • EN 12190 · EN 1542 · EN 13295 · EN 13412 · EN 13687-1/-2/-4 · EN 13057 · EN 1015-17

How to Apply

How to Apply
Same procedure as MaxPatch® M but with a finer aggregate (< 0.4 mm) for a jointless decorative finish. Saturate the substrate with water, mix a 25 kg bag with 3.5–4.0 litres of clean water (14–16 % by weight) for 2–3 minutes with a slow-speed drill (400–600 rpm), brush on a bonding slurry and trowel the mortar in layers of 1–5 mm over a substrate previously levelled with MaxPatch® M. Pot life about 20 minutes; do not add extra water.

Packaging

25 KG BAG